Basic ASA Settings : NAT, CLASS-MAP, dan POLICY-MAP

Configure ASA Interfaces

! interface GigabitEthernet0 nameif outside security-level 0 ip address 209.165.100.226 255.255.255.248 ! interface GigabitEthernet1 nameif inside security-level 100 ip address 192.168.1.1 255.255.255.0 !

Configure Telnet Services

ASA1(config)# passwd password-telnet ASA1(config)# telnet 192.168.1.0 255.255.255.0 inside ASA1(config)# telnet timeout 10

Configure Default Gateway

ASA1(config)# route outside 0.0.0.0 0.0.0.0 209.165.100.225

Hasil :

ASA1(config)# show route

----cut----

Gateway of last resort is 209.165.100.225 to network 0.0.0.0

C    192.168.1.0 255.255.255.0 is directly connected, inside
C    209.165.100.224 255.255.255.248 is directly connected, outside

S*   0.0.0.0 0.0.0.0 [1/0] via 209.165.100.225, outside

Configure NAT

ASA1(config)# object network INTRA ASA1(config-network-object)# subnet 192.168.1.0 255.255.255.0 ASA1(config-network-object)# nat (inside,outside) dynamic interface

Verifikasi :

ASA1# show run object
object network INTRA
 subnet 192.168.1.0 255.255.255.0

ASA1# show run nat
!
object network INTRA
 nat (inside,outside) dynamic interface

ASA1# show nat

Auto NAT Policies (Section 2)
1 (inside) to (outside) source dynamic INTRA interface

    translate_hits = 3, untranslate_hits = 96

ASA1# show xlate
0 in use, 2 most used

Testing ping dilakukan dari Klien A (SLAX-1) menuju network lua, dan berikut adalah hasil capture packet dari link antara ASA1 dan router ISP.

Terlihat, NAT sudah beroperasi dengan baik, Tapi..

Ping dari sisi klien (SLAX-1) terlihat tidak berjalan

Karena alasan tertentu, trafik ping bisa keluar dari ASA menuju network luar tapi trafik tersebut tidak diijinkan masuk kembali (ke ASA).

Configure Policy

Buat class-map dan policy-map untuk meng-inspect trafik ICMP.

ASA1(config)# show run class-map
!
class-map inspection_default
 match default-inspection-traffic
!

ASA1(config)# show run policy-map
!
policy-map global_policy
 class inspection_default
  inspect icmp
!

ASA1(config)# show running-config service-policy
service-policy global_policy global

ASA1(config)# show run
------cut----------
!
class-map inspection_default
 match default-inspection-traffic
!
!
policy-map global_policy
 class inspection_default
  inspect icmp
!
service-policy global_policy global
------cut----------

Hasilnya

DONE!!!

Sumber :https://akhmadkun.wordpress.com/2012/11/12/basic-asa-settings-nat-class-map-dan-policy-map/

InfoKomputer